Product Details:

Total length: 78mm

Material: stainless steel

Air inlet: 1/4", please insert pipe with 6MM or 8MM

Bore Diameter: 0.5MM 0.8MM 1.0MM 1.5MM 2.0MM 2.5MM 3.0MM 3.5MM 4.0MM

Nozzle Size: 9/16"

Features:

· The use of compressed air to swirl inside the tubes and mix the impact of the atomized droplets.

· Can produce tiny micro-sized fog particles at low pressure and low volume conditions.

· Can control air flow and pressure to adjust spray flow, angle and size granularity.

· As the fluid passage of the nozzle is large, it has good anti-clogging effect.

· In heavy oil, waste oil burner, oil and other applications, the viscosity of the liquid atomization effect is very good.

· The working pressure range is 0-10/kg/cm2, different flow capacity needs different filter screen

Flow capacity range is 1.5-1.7 L/h, requires 45um oil filter screen

Flow capacity range is 1.89 to 3.78 L/h, requires 75um oil filter screen

Flow capacity range is 4.76 to 5.10 L/h, requires 125um oil filter screen

Flow capacity range is 5.68 to 41.64 L/h, requires 140um oil filter screen

Flow capacity over 45.42 l/h, no need for oil filter

The operating pressure is 3 bars:

Diameter of 0.5mm, the liquid water flow rate is 4 L/H;

Diameter of 0.8mm, liquid water flow rate is 6 L/H;

Diameter of 1.0mm, liquid water flow rate is 8 L/H;

Diameter of 1.5mm, the liquid water flow rate is 11L/H;

Diameter of 2.0mm, the liquid water flow rate is 14L/H;

Diameter of 2.5mm, the liquid water flow rate is 17L/H;

Diameter of 3.0mm, the liquid water flow rate is 20L/H;

Diameter of 3.5mm, the liquid water flow rate is 23L/H;

Diameter of 4.0mm, the liquid water flow rate is 26L/H;

The siphon height is 30cm and the spray angle is 15-45 degrees.

Please note that the above data is based on water for reference

Test:

Normally, the working pressure is 3 bar, for the 1.00mm version, the liquid waste is 10L/H. For the 2.0mm version, the liquid waste is 19L/H. For the 3.0mm version, the liquid waste is 28L/H. The capacity tolerance is ± 10%. The siphon height is 30cm and the spray angle is 45 degrees.

Please note that the above data is based on water for reference, if you use other liquid, you can calculate it according to the density proportion.

Facility:

The air compressor must be capable of delivering at least 10% more air than the specified values. All fuel and airline connections must be tight. Any leaks, especially in the fuel line, will adversely affect the lift characteristics.

The nozzle will flow in either a horizontal or vertical position. The lift distance for a vertically mounted nozzle is measured from the liquid level to the tip (face) of the nozzle. The lift distance for horizontal mounting is shown in the installation drawing.

If the combustion application does not allow the use of a constant level device, excellent atomization characteristics can be achieved by using a fuel metering pump and an air compressor. It is also possible to operate the nozzle in a closed pressurized system using air pressure to lift and atomize the fuel.